top of page
Hunter Wyatt Studio


The Carving Burrs I Use for Skull Carving: The Must-Haves and What Each One Does
If you want to start carving skulls, you do not need a drawer full of burrs. Most of my carvings are done with just a few: a Dremel 106 ball burr for outlining, an inverted cone burr (like the Dremel 108) for clean lines and edges, and carbide cross-cut burrs for carving down layers around a design. Everything else on this list — cup burrs, diamond discs, ball burrs for stippling, cylinder and flame burrs, diamond burrs, and used dentist burrs — fills a specific job. Here is

Hunter Richardson
Oct 3010 min read
bottom of page